|
OILING:
For Natural finish (untreated) bats:-
Before use, apply a light coat of raw linseed oil (bat oil) to the
face, back edges and toe with the fingers and palm of the hand.
Avoid oiling the splice area.
3 or 4 further light coats should be applied to the face, edges
and toe at about weekly intervals. Clean the bat using fine sand
paper before each application. Repeat occasionally if the bat is
very dry.
After oiling lay the bat flat for a few hours.
For bats with a cover on the face:-
Apply oil as described above, but only to the back, uncovered edges
and toe.
For polycoated bats:-
No oiling is required, however, during play the polycoating will
wear from the toe area and the exposed willow should be lightly
oiled as described above.
KNOCKING
IN:
All Gunn & Moore bat faces have been expertly pressed to provide
an optimum resilient playing surface and do not need further pressing.
However, the face, especially the front edges, will be further improved
and its useful life prolonged by careful 'knocking-in' with an old
leather cricket ball, or a specially designed Gunn & Moore bat
mallet.
A few words of caution: take great care when knocking in the edges
and toe as hitting too hard may crack the willow - take your time
and be patient! The blade should be knocked in on the face of the
bat including the edge of the face but not on the sides of the blade,
the underneath of the toe or back of the blade.
PLAYING
IN:
After knocking-in, the bat should be used to hit short catches and/or
"throw-downs" with an old, good quality cricket ball.
It is advisable to initially avoid use against a new ball in either
nets or a match.
MAINTENANCE:
To maintain your bat in peak condition we recommend you to follow
this simple advice.
Don'ts:-
| Don't |
expose to extremes
of temperature |
| Avoid |
prolonged
spells in Car Boots/Trunks/Interiors |
Don't
|
over-oil. It is more
dangerous to over-oil than to under-oil. Over-oiling adds weight,
spoils driving power and may cause rot. |
| Don't |
ever, ever stand
the bat in oil. |
| Don't |
allow the bat to
become damp. |
| Don't |
misuse or treat carelessly
off the pitch, for example at nets, or in changing rooms. |
| Don't |
use cheap hard balls.
These will damage the bat. |
| Don't |
continue to play
with a damaged bat; this will aggravate the damage to a point
where the bat may be beyond repair. |
Do's:-
| Do |
prepare the bat carefully |
| Do |
store the bat in off-season
in a cool dry atmosphere away from excessive heat or damp. |
Do
|
re-oil the bat after any prolonged
period of non-use: it's particularly important to remember to
do this prior to using in pre-season indoor nets. |
| Do |
inspect the bat regularly for damage
in play and repair promptly. |
REPAIRS
& SERVICE:
In normal use, superficial face and edge marks along with slight
surface cracking will occur. This is to be expected; it does not
detract from the performance of the bat and may be ignored.
Other damage, such as splitting of the toe as a result of hitting
a yorker, or damage caused by a mis-timed shot (which happens to
even the best player!) can more often than not be repaired and the
repaired bat will continue to give excellent service.
United Kingdom:
Ideally the bat should be returned to the dealer from whom it was
purchased; they should quickly be able to evaluate the problem and
assess the extent and viability of any work that may be necessary
and make arrangements with us to have this carried out for you.
Alternatively, if this is not possible you should send your bat,
with your name and address fixed to it, direct to:
Gunn & Moore
Trent Lane
Nottingham
NG2 4DS
We will inspect promptly and submit an estimate before executing
the repair.
Overseas:
Please contact your local dealer.
|
